Using Accushot as a general RS232 Terminal.
In the case below Accushot goes into a dumb terminal mode.

At the moment, Accushot does not provide any software drivers
 other then for CE-3 device. For other devices
you may have to  use a custom setup.
 

Shooting Chrony selection. In this example,
Accushot displays  whatever Shooting Chrony sends out.
("Shooting Chrony" is a trademark of Shooting Chrony Inc)

Here, 7 shots were fired (electronicaly) over
Shooting Chrony, and this is what came out.


You can force Shooting Chrony chronograph
 to download all the shots from its internal memory,
using the left pushbutton on the chronograph.
 
This pushbutton sequence  was found on the internet,
we are not sure if this always works.
Press & release the left pushbutton button until
"_To_" appears,
when "_To_" appears keep holding down
without releasing it until "_MC_" appears,
when "_MC_" appears,
release the button,
when you release the button "_SE_" will appear,
now push the button again.
This starts to download internal memory.
We do not know the exact format ,
but here is what comes out.


This is what came out of the chronograph that we own.
In this case the unit was setup for metric values.
Check Shooting Chrony website for metric setup procedure.

("Shooting Chrony" is a trademark of Shooting Chrony Inc)